Industrial and Marine Insulation

Exhaust/Pipe Lagging - Removable & Re-usable

 "The lagging went on perfectly. The customer was very pleased with the end result and it insulated very well. 

Will be sure to use your company again."

 Regards

 Jacob
Automation Design Engineer
General Marine Services, Auckland

Made here in our factory in Nelson,  our exhaust/pipe lagging (insulation) is sent all over New Zealand & overseas.  We fabricate off your plans.  You'll even find our lagging down in Antarctica.

 

All products are fabricated from top quality materials that can withstand a wide range of temperatures. Longevity & value for money is the approach we take.

 

Our blankets are sewn using heat resistant thread and secured using stainless steel wire with stainless steel lacing anchors and backing washers. We use stainless steel mesh as a backing so that the blankets resist chafing on high vibration areas.

 

The outer material we use has a silicone layer that stops any moisture getting into the blanket & is able to withstand 550 degrees C constant temperature.

 

The inner blanket is a 25mm E-Glass anti-vibration needle mat also able to withstand 550 degrees C constant temperature.

 

 

Removable/Re-usable

Modular – made up in convenient size panels or sections which can easily be installed or removed by your own crew with basic knowledge of exhaust lagging removal/fitting procedure – only the required blankets have to be removed to enable a particular maintenance or inspection job to be done. After service/maintenance the blanket can be replaced without special tools.

 

Our removable blankets are sewn using heat resistant thread and secured using stainless steel wire with stainless steel lacing anchors and backing washers. We use stainless steel mesh as a backing so that the blankets resist chafing on high vibration areas.

 

Although slightly more expensive than permanent metal insulation, it becomes more and more economical every time you remove and replace a module. These blankets are ideal for engine manifolds, turbochargers, flexes, expansion joints, valves of all types, flanges, sight glasses and also any equipment that has to be repaired/serviced on a regular basis.

 

Whether the measurements are taken on-site or plans are supplied, the blankets are made at our factory, and then installed by our team or by your crew.

 

 

Insulation Benefits

  • Enhances worker safety
  • Maximises effectiveness of catalytic converters & therefore fuel consumption
  • Reduces ambient heat
  • Protects heat sensitive equipment
  • Reduces possibility of fires
  • Provides a better working environment

 

Download
TM Covers Industrial & Marine Insulation
TM Covers Lagging.pdf
Adobe Acrobat Document 4.2 MB

Showroom and Factory

143 St Vincent Street

Nelson

New Zealand

 

Telephone 03 546 6809

Freephone 0800 665 506

Email sales@tmcovers.co.nz

Facebook TM Covers

 

Opening Hours

Monday - Friday 8am - 5pm

Member of: